@Josh Swales morning, had to post new thread as it would only allow 1 pic in reply 😄 are you using raspbian OS? As below screenshots are for rasbian. First pic shows the top right, clicking on the up/down arrows and shows wifi disabled, click to enable. If already enables or enabled in previous step, second pic shows what wifi are in range, click on your one, then next pic shows asking for the wifi password, once entered its done. Once done, go back to the top right corner, note the up/down arrow has changed to a wifi sign, shown in pic 4, hover the mouse over it, but dont click, this will show what ip addresses are set, note the one that has ‘wlan0: configured 192.168.1.201/24’ in pic 5’ on your pi it will be different. Then we use that new address to connect via vnc 192.168.1.201, in my case, leave the ‘/24’ off I hope that makes sense 😄 if your not using rasbian OS let me know and i’ll redo steps for it Send me some screenshots if you get stuck anywhere Note: ignore all the veth entries in pic 4, this is due to docker being installed and likely will show on your installation.

Posted by Paul V at 2021-08-16 07:51:21 UTC